An All-Inclusive Guide to Perform Netgear EX6200 Setup

Netgear Extender Won’t Connect to Router? Here’s the Fix!

If your Netgear extender won’t connect to router, it might be because of a number of reasons. Some of the topmost ones have been listed below:

  • The connection between your extender and router is not stable.
  • Your extender is not receiving an uninterrupted power supply from the wall socket.
  • The distance between your wireless devices is too much.
  • The signals of your extender are getting interrupted or blocked.
  • The firmware of your Netgear range extender is either corrupted or outdated.
  • Technical glitches can also prevent your extender from connecting to the router.
  • Your Netgear WiFi extender is damaged.

Now that you are aware of why your Netgear extender won’t connect to router, follow the troubleshooting tips mentioned below to get rid of the issue.

Fixed: Netgear Extender Won’t Connect to Router

1. Reboot Your Netgear Extender

As mentioned above, technical glitches are one of the major reasons why your Netgear extender won’t connect to router. To get rid of these glitches, it is recommended that you reboot your wireless device.

In order to give your Netgear wireless extender a restart:

  • Power off your extender and unplug it from the wall socket.
  • Hold on your horses.
  • Plug your extender back into the wall socket and turn it on.

Now, try to access www.mywifiext.net. If you are able to, it means the issue you were facing has bid adieu. On the off chance, you are not able to, follow the next troubleshooting hack.

2. Check the Power Supply

Make sure that the wall socket into which you have plugged your Netgear extender is in working condition.

In case it isn’t, then you can opt for either of these options:

  • Get your wall socket fixed.
  • Plug your Netgear range extender into a different wall socket.

If you are still unable to access the mywifiext setup wizard, it is recommended that you get in touch with our technical experts.

3. Verify Your Ethernet Connection

The Ethernet cable connecting your Netgear range extender and the wireless router should not be worn out or damaged from anywhere.

If a wired connection is not working well for you, consider connecting your devices with the help of a wireless source.

4. Bring Your Devices Closer

Apart from ensuring a proper connection between your Netgear extender and the existing router, see to it that the distance between them isn’t too much.

Make sure that your extender is placed in the same room as the router. But, your devices should not be placed too close. Or else, their WiFi signals won’t take much time to clash.

5. Get Rid of Signal Interference

Are you still struggling with the Netgear extender won’t connect to router issue? Well, if that is the case, then you shouldn’t waste any more time relocating your extender.

While relocating your device, avoid placing it near cordless phones, washing machines, baby monitors, washing machines, Bluetooth speakers, mirrors, fish tanks, treadmills, televisions, refrigerators, microwave ovens, aluminum studs, corners, and concrete walls.

6. Reset Your Netgear Extender

If nothing has worked for you so far, there is no better option than performing factory default reset for you.

Follow the instructions mentioned below and learn about the process to reset your Netgear wireless range extender:

  • Look at the Reset hole located on your wireless device.
  • Get hold of an oil pin and carefully insert it in the Reset hole.
  • Wait for a couple of seconds.

Once you have restored your extender to the factory default mode, reconfigure it via 192.168.1.250.

The Bottom Line

With that, our guide to troubleshoot the Netgear extender won’t connect to router issue has come to an end here. We hope that the hacks mentioned in this post helped you resolve it. On the off chance, they didn’t, feel free to get in touch with our well-versed experts.